Ill try again.

Got it and email sent.

Thanks

I got my baseplates today. They work perfectly. Thank you again for your efforts.

I just wanted to say that Brad's little invention arrived on Saturday and I've tried it on for size. Looks great and feels better! My pinky used to ride the old base plate so this is a big improvement.

This message has been edited. Last edited by: trex021,

bdavis, could you send me your email address?

For some reason I can't open your profile.


Thank you!

trex021 those look good with the Pachmayrs

944turbo the email is bdavis22 at gmail dot com (remove spaces and correct the symbols)

In for two. Email sent.

quote:

Originally posted by bdavis:
trex021 those look good with the Pachmayrs

944turbo the email is bdavis22 at gmail dot com (remove spaces and correct the symbols)

Thanks. I can't wait to shoot it this weekend. The Pachmayrs showed the same day as your baseplates.

got mine today and put them on..... Absolutely wonderful.
It makes the gun fit my hand and feels great.

Thank you to all who have ordered. Here is a picture of an excellent example done by user kababis22. Those bases look great with the new Hogue grips.

I need some of these. Email inbound

Bump --

Got my two today. These rock.

These look very good !!

Received mine today, they are very nicely done and I like them much better than the stock baseplates.

Thanks Brad!

Thank you to all who have ordered. I am down to my last 2 bases on this run.

You can send me an email or post with the number of bases you would like and I will let you know when the next run is finished.

Thanks again

Could you look into a baseplate to convert the P1 mag to work in a P6. There was a thread on here about that, and if that were possible, that would make a lot more magazines availble for use...

I have only owned a p225 for a while. Do these plates typically go bad.

quote:

Originally posted by G32-357sig:
I have only owned a p225 for a while. Do these plates typically go bad.

There's a thread somewhere on the Pistols board talking about how P225/P6 baseplates can bend when the magazines are kept fully loaded for long periods of time. If you look at the photo a few posts up, you'll see that Brad's baseplates are lower profile at the front than the stock baseplates. They're basically flush with the frontstrap, and don't stick out as far as the stock baseplates.

Brad,

Will you be running another batch of your baseplates in the not too distant future? I'm hoping to purchase at least a couple of these eventually, but just couldn't do it during the current round.

Thanks,

ST

If the last two baseplates are still available I'll take them. E-mail sent.

E-mail sent...