Hi Folks,

We have a Bosch dishwasher that is not cleaning the dishes. It is an SHV46C13UC. It starts, make the usual start up noises. Then you can hear water trickling. It doesn't seem to be spraying water. When it finishes there is standing water in the bottom. If we do the reset sequence (hold two buttons down for three seconds) the water will flush out, and we get the beeps indicating the washer has reset. We have checked the spray arms and they are not clogged. We have cleaned the drain.

We have replaced the main electronic panel in the in the door (the one that is connected to the buttons) and the solenoid. We know there is plenty of pressure to the solenoid.

We are a bit stumped at this point.

Any thoughts or suggestions?

TIA

Chance

Sounds like it isn't exchanging the dirty water - drain.

You could have a plugged anti siphon valve or a bad pump. Did you take the cover plate off of the pump impeller? Could have junk in there.

Put some dry glasses on the top rack and run a short test. Let the washer fill and run for a minute or two, see if the glasses are wet. This to confirm circulation.

Also, there is a / followed by numbers to complete the model number.

I had a dishwasher doing something similar and it was the pump unit. In my case it was nto worth fixing