Moderators: Chris Orndorff
|
Go
|
New
|
Find
|
Notify
|
Tools
|
Reply
|
|
|
Member |
I rec'd my SIG sight pusher/tool from TopGun and I'm not quite sure how to use the "alignment marks/notches" on the tool. I understand everything else. Any ideas? Is there a video using the MGW tool? I will check YouTube.
Thanks, paul |
||
|
Member |
I wouldn't worry about those too much since i found them to be a close approximation of where the sight should be and then i fine tune a little bit after some test shooting.
---------- Yes, as a matter of fact I do own a gun. Free Classic P-Series Sig Armorer services on Long Island and around the NYC area. |
|||
|
Member |
I have never used the marks. I center the front sight by eye and adjust the rear sight at the shooting range.
|
|||
|
Member |
I don't usually look at the marks either.
http://www.topgunsupply.com SIG SAUER Factory Parts Distributor Dealer: Handguns, Shotguns, Rifles, Receivers Night Sights, Holsters, Magazines, Grips, Shooting Supplies |
|||
|
| Powered by Eve Community |
 | Please Wait. Your request is being processed... |
|
© SIGforum 2009