SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    new member question

Moderators: Chris Orndorff
Go
New
Find
Notify
Tools
Reply
  
new member question Login/Join 
Member
posted
hey guys
soon to own a new hampshire 220
can i put the factory 2 pc slim grips on a 220
ser g 315 xxx wo mods
and as a second ? can i put a short trigger in it
for my med to shorter finger reach
thanks for any help u can give me
best...
 
Posts: 5 | Registered: September 15, 2017Reply With QuoteReport This Post
Member
posted Hide Post
I think both of those should work.
I had slim grips on a P220 Carry.

Luck,

Bruce



Hanlon's Razor /prov./ A corollary of Finagle's Law, similar to Occam's Razor, that reads "Never attribute to malice that which can be adequately explained by stupidity."

"It is better to be considered a house cat and sit on the lap of pretty girls than to be feared as a tiger and hunted by men."- T. Takamatsu
 
Posts: 2414 | Location: NV | Registered: October 06, 2011Reply With QuoteReport This Post
Freethinker
Picture of sigfreund
posted Hide Post
If that pistol uses the short mainspring and plastic mainspring seat, the “slim” grips will fit with no problem.

As for the trigger, I believe that gun is old enough that it uses the narrow, 8mm-wide trigger, and not the current 10mm version. If so, original factory short reach 8mm triggers are pretty scarce. There are modification options available, including grinding down the original grooved trigger to the short reach configuration.




“Most men … can seldom accept the simplest and most obvious truth if it … would oblige them to admit the falsity of conclusions … which they have woven, thread by thread, into the fabrics of their lives.”
— Leo Tolstoy
 
Posts: 37143 | Location: 10,150 Feet Above Sea Level in Colorado | Registered: April 04, 2002Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    new member question

© SIGforum 2017