SIGforum
P225 German Frame: SRT Options

This topic can be found at:
https://sigforum.com/eve/forums/a/tpc/f/150601935/m/8260032324

April 24, 2017, 02:16 PM
rjheisler
P225 German Frame: SRT Options
Hello. Will the SRT kit for the P226/P229 work in a German frame P225? I am looking at my M11-A1 with the slide off and the witdth of the sear looks to be the same width of the sear in my P225. I suppose I could take the SRT out of the M11-A1 and see if it works in the P225.
April 24, 2017, 05:59 PM
stoic-one
The P226 SRT kit should work fine.


__________________________________

NRA Benefactor
I lost all my weapons in a boating, umm, accident.
http://www.aufamily.com/forums/
April 24, 2017, 11:04 PM
bumper
After installation of the SRT, I suggest checking to make sure the firing pin safety block plunger is being lifted enough to clear the FP.

You might do the "pencil test", dry fire w/pencil eraser end down barrel, pointed up, and note how far pencil goes up (do several times). Repeat after SRT install.

Do this in DA for a DA/SA gun.

If you've already installed the SRT (too late to compare), then push on rear of FP, restrain hammer w/ thumb, and dry fire. FP block should clear before sear release - even if a tiny bit.

Problem is the amount of lift or the SRT safety lever can be marginal, resulting in FP impacting FPB enough to take energy from FP.
April 26, 2017, 01:22 PM
rjheisler
I called Sig customer service and was told that the SRT kit sold for the P226/P227/P229 will work in the German frame P225.