February 20, 2018, 06:14 PM
les45Sig 229 grip question
I finally got the old style grips to replace the E2 grips on my Sig 229 SAS. When I first installed the grips, the gun would not operate in double action. It would work if I thumbed it back into single action. I removed the right side grip and everything worked OK. After re-installing the right side grip several times with the same results, it finally started working OK after about the fourth or fifth try. The trigger bar spring was always in the right position. Any idea what might have caused this issue and should I have any reason for concern?
February 20, 2018, 07:39 PM
NipperIt's not unusual to damage the TBS (trigger bar spring) when installing/uninstalling E2 grips.
Hard to tell visually. Helps to have a spare TBS to verify. I had to replace a TBS on my P226 when I had the E2 grips on it.
February 21, 2018, 11:01 AM
JAFOAlso check the inside of the right grip panel to make sure there's no residual plastic flashing that could be impeding the spring.