SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    P226 Slide Parts Numbers
Go
New
Find
Notify
Tools
Reply
  
P226 Slide Parts Numbers Login/Join 
Member
Picture of RobFMJ
posted
I recently picked up an old stock bare slide and I’m trying to piece together the parts to finish it out. Slide is machined with the short external extractor.

Aside from the extractor and extractor pin (EXTRACTOR-1 and PIN-1 respectively, I think), which extractor spring do I need? I see references in some listings to inner and outer springs, but I was under the impression it’s just a single spring.

For the firing pin, I need the new style pin (SST, FIRING-PIN-5), firing pin spring (SPRING-1) and one of the spiral-type firing pin retaining pins (PIN-11? -12?), correct?

Lastly, which type safety lock (LOCK-1/LOCK-2) and safety lock spring (SPRING-2/SPRING-4) is correct for this iteration slide?

https://i.imgur.com/aockMQX.jpg
https://i.imgur.com/MaEUEYQ.jpg
 
Posts: 97 | Location: Galveston, TX | Registered: June 04, 2007Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    P226 Slide Parts Numbers

© SIGforum 2024