August 31, 2019, 01:33 PM
moelarrycurlyLocking insert won't align
It's been awhile since I went through the armorer class. I admit I'm a bit rusty.
I have a 15 year old p228. I installed a 20 lb Wolff hammer spring and a factory short trigger. I can't get the locking insert to align properly. It is too far forward. I can't insert the takedown lever.
Any suggestions would be appreciated.
August 31, 2019, 02:16 PM
Mustang-PaPaRotate the trigger pivot pin 180* and then re insert the locking block.
October 13, 2019, 09:38 AM
apf383As Mustang said above. If you got it out, it will go back in. They are a pain in the dick though.