Is this the correct extractor for the old "folded" slide?????proper extractor???

The seller shows a photo of the folded slide but the curve in middle of the shaft is causing me pause. Thanks in advance for your help.

They look about right, however, I cannot confirm that part number.

quote:

Originally posted by Prince Herman:
Is this the correct extractor for the old "folded" slide?????proper extractor???

The seller shows a photo of the folded slide but the curve in middle of the shaft is causing me pause. Thanks in advance for your help.

Comparing to the one listed at TGS, which they show out of stock, it appears to be the correct part, and the part numbers match up. But you are right, it does appear the one shown on eBay has been bent somewhat. Hard to tell, as they show quite a few examples.
 

Here is a picture of three of mine.
The bottom one was made by GerryR and the top two are out of a P228 but new.