SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    P239 SRT Parts question

Moderators: Chris Orndorff
Go
New
Find
Notify
Tools
Reply
  
P239 SRT Parts question Login/Join 
Junior Member
Picture of PPS1980
posted
The SRT kit for the P239 is either long gone of really dearly priced these days. In looking at the parts included it looks to me like the SRT Sear (1200457R) and the SRT Safety Lever (Lever-9) are the only parts in the kit, is that correct?


I prefer dangerous freedom over peaceful slavery.
- Thomas Jefferson 1787
 
Posts: 4 | Registered: October 23, 2020Reply With QuoteReport This Post
Member
posted Hide Post
And the trigger bar return spring.

The trigger bar return spring aft end that catches in the trigger bar notch has to be shortened approximately .040" so it does not interfere with the long fingered SRT firing pin safety lever.

DA/SA SRT sear & safety bars are the same.


Favor Center,Mass.
 
Posts: 63 | Location: Fbks,AK. | Registered: March 23, 2020Reply With QuoteReport This Post
Texas Proud
Picture of texassierra
posted Hide Post
I just installed two P239 SRTs today. I used P226, P229, etc. kits and I ordered what I thought were the appropriate return springs but they ended up being the same as the original. I just used a pair of small snips and took off a little. Worked like a charm.


NRA Life Patron
 
Posts: 1680 | Location: DFW | Registered: March 28, 2004Reply With QuoteReport This Post
  Powered by Social Strata  
 

SIGforum.com    Main Page  Hop To Forum Categories  SIG Armorer    P239 SRT Parts question

© SIGforum 2020